setup reset

Return to the factory-default configuration and reboot the unit.

setup reset [all|clear]

set reset Resets the PacketShaper settings (for example, NIC speed and IP address, but not the traffic tree) to the factory default state, and then reboots the unit
set reset all

Resets all settings and the configuration to the factory default state

Note: Use setup reset all only when you want to reset all configuration settings — basic configuration, the traffic tree with its classes, policies, and partitions; measurement data; and events — to the factory-default settings. This command deletes all custom service groups and returns any moved services back to their original groups.

set reset clear Clears all files on the system disk (9.256/), in addition to resetting all settings and the configuration to the factory default state

These commands reset the unit's IP address to 207.78.98.254, making it unreachable on your network until it is reconfigured using Guided Setup. (See Run Guided Setup for details.)

Note: The setup reset command works differently in shared mode.

To reboot the unit without modifying the settings, use the reset command.

Command Change History
Release
Modification
8.3.1
The clear parameter is introduced.

 

        

PacketGuide™ for PacketWise® 9.2